EnGenius EOC-8610-S series User Manual download pdf (Page 9)

11a/b/g Wireless Multi-Client Bridge/AP/WDS Version 1.0

2 Understanding the Hardware

2.1 Hardware Installation

1. Place the unit in an appropriate place after conducting a site survey.

2. Plug one end of the Ethernet cable into the AP port of the PoE Injector and the

other end into the Bridge/AP.

3. Place one end of another Ethernet cable into the Network port of the PoE Injector

and another end into your PC/Notebook.

4. Insert the DC-inlet of the power adapter into the port labeled “DC-IN” and the

other end into the power socket on the wall.

This diagram depicts the hardware configuration

2.2 IP Address Configuration

This device can be configured as a Bridge/Router or Access Point. The default IP

address of the device is 192.168.1.1 (Client Bridge mode), 192.168.1.2 (Access

Point mode). In order to log into this device, you must first configure the TCP/IP

settings of your PC/Notebook.

1. In the control panel, double click Network Connections and then double click on

the connection of your Network Interface Card (NIC). You will then see the

following screen.

PoE In

ectorPC

Power Outlet

Ethernet

AC/DC cable

Brid

e/AP

Ethernet

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 54 55

No comments

EnGenius EOC-8610-S series User Manual Page 9