EnGenius ESR900 Specifications download pdf (Page 122)

122

Routing Setup

Typicallystaticroutingdoesnotneedtobesetupbecausetherouterhasadequateroutinginformationafterithasbeencongured

forInternetaccess.Staticroutingisonlynecessaryiftherouterisconnectedtonetworkunderadifferentsubnets.

ToviewtheRoutingsettings,clickAdvanced then select Routing.

Note: Toenableastaticrouting,NATmustbedisabled.

Iftherouterisconnectedwithanetworkunderthedifferent

subnet,theroutingsetupallowsthenetworkconnectionwithin

twodifferentsubnets.

Enable Static Routing

ClickEnableStaticRoutingtoactivatethefeature.

Destination LAN IP

EntertheLANIPaddressofthedestinationdevice.

Subnet Mask

EntertheSubnetMaskofthedestinationdevice.

Default Gateway

EnterthedefaultgatewayIPaddressforthedestinationdevice.

Hops

Enterthemaximumnumberofhopswithinthestaticrouting

thatapacketisallowedtotravel.

Interface

SelectLANorWANastheinterface.

ClickAddtosavethesettingsandlistthecongurationinthe

CurrentStaticRoutingtableorReset the discard changes.

View and select devices in the Current Static Routing Table.

ClickDelete Selected or Delete All to remove devices

fromthetable.ClickReset to stop.

ClickApply to save the settings or Cancel to discard changes.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 134 135

No comments

EnGenius ESR900 Specifications Page 122