EnGenius ENH200 User Manual download pdf (Page 55)

100

8.5 Wireless MAC Filter

Wireless MAC Filters are used to allow or deny network access to wireless clients according

to their MAC addresses. You can manually add a MAC address to restrict the permission to

access ENH200. The default setting is Disable Wireless MAC Filters.

ACL Mode

Determines whether network access is granted or denied to

clients whose MAC addresses appear in the MAC Address table

on this page. Choices are Disable, Deny MAC in the list, or

Allow MAC in the list.

MAC Address Filter

Enter the MAC address of the device.

Add

Click Add to add the MAC address to the MAC Address table.

Apply

Click Apply to apply the changes.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 99 100

Long Range Wireless N 1
Client Bridge/Access Point 1
User Manual 1
Table of Contents 2
About This Document 5
Chapter 1 Product Overview 7
1.2 Benefits 8
1.3 Package Contents 9
1.3 System Requirement 9
Chapter 2 Hardware Overview 10
2.1BottomView 10
2.2BackPanel 10
Installation 11
5.2BestPractices 24
Chapter 6 Status 25
6.1 Save/Load 25
6.2 Main 26
6.3 Wireless Client List 27
6.4 System Log 28
6.5 Connection Status 29
6.6 DHCP Client Table 30
Chapter 7 System 31
7.1 Changing Operating Modes 31
8.1 Wireless Settings 33
8.1.1 Access Point Mode 33
8.1.2 Client Bridge Mode 37
8.1.3 WDS Bridge Mode 40
8.1.4 Client Router Mode 43
8.2.1 WEP 46
8.2.2 WPA-PSK 47
8.2.3 WPA2-PSK 48
8.2.4 WPA-PSK Mixed 49
8.2.5 WPA 50
8.2.6 WPA2 51
8.2.7 WPA Mixed 52
8.5 Wireless MAC Filter 55
8.6 WDS Link Settings 56
Chapter 9 LAN Setup 57
9.1 IP Settings 57
9.2 Spanning Tree Settings 58
Chapter 10 Router Settings 59
10.1 WAN Settings 59
10.1.1 Static IP 59
10.1.2 DHCP (Dynamic IP) 61
10.3 VPN Pass Through 68
10.4 Port Forwarding 69
10.5 DMZ 71
11.1 Administration 72
11.2 Management VLAN 74
11.3 SNMP Settings 75
11.4 Backup/Restore Settings 76
11.5 Firmware Upgrade 77
11.6 Time Settings 78
11.7 Log 79
11.8 Diagnostics 80
12.1 Access Point 81
12.2 Client Bridge Mode 82
12.3 WDS Bridge Mode 84
12.4 Client Router 85
13.1 Access Point Mode 86
13.3 Client Bridge Mode 88
13.4 WDS Bridge Mode 89
13.5 Client Router Mode 90
13.6 RADIUS Connections 90
AppendixA–Troubleshooting 92
AppendixB–Specifications 94
AppendixC–Glossary 95
HT mode 97

Comments to this Manuals

No comments

EnGenius ENH200 User Manual Page 55

Comments to this Manuals

Related products and manuals for WLAN access points EnGenius ENH200