EnGenius ENH200 User Manual download pdf (Page 42)

6.5 WDS Link Settings

WDS Link Settings is used to establish a connection between Access Points but the device is

not losing Access Point function. AP has WDS function can extend the wireless coverage and

allow LANs to communicate each other.

MAC Address Enter the Access Point’s MAC address that you would like to

extend the wireless area.

Mode Select Disable or Enable from the drop down list.

Accept / Cancel Press Accept to confirm the changes or Cancel to return previous

settings.

Accept does not compile the changes, you must go to Status -> Save/Load to apply the new

settings. Please refer to the chapter 4.1 for more detail.

The Access Point that you would like to extend the wireless area must enter your Access

Point’s MAC address. Not all Access Point supports this feature.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 73 74

No comments

EnGenius ENH200 User Manual Page 42