EnGenius ENH202 User Manual download pdf (Page 5)

About This Document

This document is written by EnGenius Inc. EnGenius Inc. the reserves the right to change this

document without notice and all rights are reserved. This document can only be used for the

configuration of EnGenius products.

This document is to characterize the EnGenius ENH202 Wireless Access Point & Client

Bridge. Please read the document carefully before setting up the ENH202. Any damage which

is caused by inappropriate use will not be covered under the warranty.

Formats

This document uses following symbols to indicate and highlight special messages.

Caution: This symbol represents a vital message and it is critical for the device

or settings.

Note: This symbol represents an important message for the settings.

Tip: This symbol represents an alternative choice that can save time or

resources.

Before you start__________________________________________________

The following equipment is required to setup the ENH202:

1. (1) Computer/Notebook and Internet access.

2. (2) Ethernet cables.

3. (1) EnGenius ENH202.

The equipment listed above is only for configuration of the ENH202, you will

need additional equipment to connect to the Internet and configuration will depend on your

current network infrastructure. Please refer to Chapter 2 for more information.

1 2 3 4 5 6 7 8 9 10 ... 87 88

No comments

EnGenius ENH202 User Manual Page 5