EnGenius EGS7228P User Manual download pdf (Page 14)

Connecting the Switch to a Network

Discovery in a Network with a DHCP Server

Use this procedure to setup the Switch within a network

that uses DHCP.

1. Connect the supplied Power Adapter (cord) to the Switch

and plug the other end into an electrical outlet. Turn the

power switch on the back of the device to the ON

position. Verify the power LED indicator is lit on the

Switch.

2. Wait for the Switch to complete booting up. It might take

a minute for the Switch to completly boot up.

3. Connect one end of a Category 5/6 Ethernet cable into

the Gigabit (10/100/1000) Ethernet port on the Switch

front panel and the other end to the Ethernet port on the

computer. Verify that the LED on the Ethernet ports of the

Switch are green.

4. Once your computer is on, ensure that your TCP/IP is set

to On or Enabled. Open Network Connections and then

click Local Area Connecton. Select Internet Protocol

Version 4 (TCP/IPv4). If your computer is already on a

network, ensure that you have set it to a Static IP Address

  ontheInterface(Example:192.168.0.10andtheSubnet

mask address as 255.255.255.0).

5. Open a web browser on your computer. In the address

bar of the web browser, enter 192.168.0.239 and click

Enter.

6. A login screen will appear. By default, the

username is admin and the password is password.

Enter the current password of the Switch and then click

7. Once logged in, click IP Settings under the System tab

and select IPv4 or IPv6. Next,

8. Click DHCP underAuto-Conguration.

9. Click Apply to save the settings.

10. Connect the Switch to your network (DHCP enabled).

11.OntheDHCPserver,ndandwritedowntheIPaddress

allocated to the device. Use this IP address to access

the management interface.

IP Address: ________________________________________

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 150 151

No comments

EnGenius EGS7228P User Manual Page 14