EnGenius EGS7228P User Manual download pdf (Page 94)

Trap Settings

SNMP Traps

A trap is a type of SNMP message. The Switch can send

traps to an SNMP manager when an event occurs.

You can restrict user privileges by specifying which por-

tions of the MIBs that a user can view. In this way, you

restrict which MIBs a user can display and modify. In

addition, you can restrict the types of traps the user can

send. You can do this by determining where messages

are sent and what types of messages can be sent per

user.

Server IP/Hostname:

Enter the Server IP or Hostname. The

Hostnamecancontainupto128alpha-

numeric characters.

SNMP Version:

Select the SNMP version from the list.

Notify Type:

Selectthetypeofnoticationtobesent.

• Traps – Traps are sent.

• Informs – Informs are sent ONLY

when v2c is enabled.

Community Name:

Select the Community Name from the

list.

UDP:

EntertheUDPportusedtosendnotica-

tions.

Timeout:

Congurableonlyifthenotifytypeis

Informs. Enter the amount of time the

device waits before re-sending. The de-

fault is 15 seconds.

Retry:

Congurableonlyifthenotifytypeis

Informs. Enter the amount of time the

device waits before re-sending an inform

request. The default is 3 seconds.

Click the Apply button to accept the changes or the

Cancel button to discard them.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 150 151

No comments

EnGenius EGS7228P User Manual Page 94